久久国产一级片一区二区_久久久久深夜毛片_污污视频在线免费观看_后进极品翘臀在线播放_亚洲精成99国产_最新国产vr麻豆aⅴ精品无_波多野结衣中文字幕四区_中文字幕在线永久资源_好紧好爽水真多18p真人_欧美α一级视频免费播放

The design of water-assisted injection molding equipment must meet the conditions similar to gas-assisted injection molding. This is because most process technologies are based on gas-assisted injection molding. However, water-assisted injection molding also has its own characteristics. From the point of view of plastic parts, except that drainage is more complicated than the removal of nitrogen gas, it is necessary to complete the “drainage” of plastic parts through gravity and the introduction of compressed gas. In order to prevent corrosion, water must not come into contact with the mold surface.

Water-assisted injection molding requires extremely high water injection capacity to ensure uniform wall thickness distribution and high surface quality. For this reason, suitable pressure control mode. The water supply operates at an extremely high flow rate and can reach a pressure of 350 bar. In order to inject water into the melt, an injection assembly with a larger cross-sectional area than gas-assisted injection must be used, which is essential for water to penetrate into the melt at a sufficient speed.

The design of water-assisted injection molding equipment must meet the conditions similar to gas-assisted injection molding. This is because most process technologies are based on gas-assisted injection molding. However, water-assisted injection molding also has its own characteristics. From the point of view of plastic parts, except that drainage is more complicated than the removal of nitrogen gas, it is necessary to complete the “drainage” of plastic parts through gravity and the introduction of compressed gas. To prevent corrosion, water must not come into contact with the mold surface.

Water-assisted injection molding requires extremely high water injection capacity to ensure uniform wall thickness distribution and high surface quality. For this reason, suitable pressure control mode. The water supply operates at an extremely high flow rate and can reach a pressure of 350 bar. In order to inject water into the melt, an injection assembly with a larger cross-sectional area than gas-assisted injection must be used, which is essential for water to penetrate into the melt at a sufficient speed.