久久国产一级片一区二区_久久久久深夜毛片_污污视频在线免费观看_后进极品翘臀在线播放_亚洲精成99国产_最新国产vr麻豆aⅴ精品无_波多野结衣中文字幕四区_中文字幕在线永久资源_好紧好爽水真多18p真人_欧美α一级视频免费播放

1, injection molding machine settings

o The raw material drying temperature is consistent with the traditional molding

o The barrel plasticizing temperature is higher than traditional injection molding

o The mold temperature requirement is strict, and the cooling water circuit layout should balance the cooling effect

o Injection pressure is basically the same as traditional injection molding

o Injection speed is generally high-speed filling

o injection molding machine injection pressure can be disabled

2. Setting of high-pressure nitrogen equipment

a, the maximum pressure of the high pressure nitrogen generator is generally set not more than 35Mpa

b. Parameter setting of nitrogen pressure controller (gas pressure, gas holding time, lifting pressure rate, start delay)